Masterbuilt
Weak Heating Output or Heat Loss
Smoker heats but cannot reach set temperature; stalls 30–50°F below target even after long preheat.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially failing heating element, Door gasket leaking heat, Damaged or missing rear vent cover, Faulty cabinet temperature sensor reading high
How to Fix / Troubleshooting
Safety first: Unplug the smoker and let it cool before inspecting seals or wiring.
- Check door seal: Inspect the silicone door gasket around the opening. Look for gaps, tears, or hardened sections. Replace the gasket if it does not seal evenly.
- Inspect vents: Ensure the top exhaust vent is present and adjustable. A missing or fully open vent can cause excessive heat loss; adjust to a partially open position during cooking.
- Test element performance: With the smoker empty, set to a high temperature (e.g., 275°F) and monitor how quickly it heats. If it climbs very slowly or stalls, test the element resistance and compare to specifications; a high resistance may indicate a weak element.
- Verify sensor accuracy: Place an oven thermometer inside the smoker and compare to the display. If the display reads much higher than actual, the cabinet sensor may be faulty and should be replaced.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements