E5
Flymo
Lift or Tilt Sensor Activated
Robot mower displays E5 and stops; often after hitting an obstacle or when lifted slightly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Mower lifted during operation, Excessive slope beyond specification, Faulty tilt sensor on main PCB, Loose chassis or damaged tilt switch bracket
How to Fix / Troubleshooting
Safety first: Ensure the mower is on level ground, switch it OFF, and wait for all moving parts to stop.
- Check operating conditions: Confirm the mower is used only on slopes within the maximum gradient specified by Flymo. Avoid steep banks and steps.
- Inspect wheels and chassis: Look for broken wheel mounts, cracked chassis, or anything that allows the mower body to tilt excessively during normal driving.
- Clean around wheels: Remove grass clumps that may cause the mower to ride unevenly and trigger the tilt sensor.
- Reboot: Turn the main switch OFF for 30 seconds, then ON again and start a new cycle.
- Sensor check: If E5 appears even when the mower is stationary on flat ground, the tilt/lift sensor or main PCB may be defective and should be inspected or replaced by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements