Beko Outdoor Coil Icing / Defrost Failure

Outdoor unit covered in ice during heating mode

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Defective defrost sensor, Defrost control failure on outdoor PCB, Low refrigerant charge, Outdoor fan not running properly

Safety: Turn off power before removing ice manually. Do not use sharp tools on the coil.

1. Turn unit off: Allow ice to melt naturally. You can pour lukewarm (not hot) water over the coil to speed melting.
2. Check outdoor fan and coil cleanliness: Ensure the fan runs and the coil is clean.
3. Inspect defrost sensor: Confirm it is attached to the coil and wiring is intact.
4. If icing recurs quickly: A technician should test the defrost cycle, sensor, and refrigerant charge.

Hard 4/5

Outdoor Defrost / Coil Temperature Sensor (NTC)

Check Price on Amazon

We may earn a commission from links on this page.