Beko Timing Circuit / MCU Fault

Timer does not count down correctly; cooking ends too early or continues past zero.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Faulty main control PCB microcontroller, Software glitch, Unstable power supply to control board

Steps to address timing issues:

Power reset: Unplug for 10–15 minutes to reset the control logic.
Test with short cycles: Run a 5-minute cycle and observe if the countdown is accurate.
Inspect PCB: If timing remains erratic, the main control PCB is likely defective and should be replaced.

Medium 3/5

Main Control PCB

Check Price on Amazon

We may earn a commission from links on this page.