P2
Electrolux
Program Memory / EEPROM Error
P2 code appears and cooking programs cannot be started or are interrupted.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted program memory on control PCB, Voltage spikes during operation, Defective main control PCB, Poor connection between display and logic board
How to Fix / Troubleshooting
Safety first: Unplug the unit before any disassembly.
Steps:
- Factory reset (if available): Consult the user manual for a reset procedure (often holding specific buttons for several seconds). Perform the reset and test again.
- Power cycle: Unplug for 10–15 minutes to clear volatile memory, then reconnect.
- Inspect connectors: Open the control panel and reseat any ribbon cables between the display and main PCB.
- Board replacement: If P2 persists after reset and connector checks, the EEPROM or microcontroller on the main PCB is likely faulty. Replace the main control PCB.
Note: Memory chips on these boards are not typically field-reprogrammable; replacement is the standard repair.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements