E9
Emeril Lagasse
EEPROM / Memory Error on Control Board
Display shows E9 and the Emeril Lagasse air fryer will not start or immediately shuts off.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware, Failed EEPROM chip on main control board, Voltage spike damage, Manufacturing defect in control PCB
How to Fix / Troubleshooting
Safety first: Unplug the unit before any disassembly.
- Power cycle: Unplug for at least 15 minutes to fully discharge the board, then plug back in and attempt to start a basic cycle.
- Check power quality: Avoid using long extension cords or overloaded power strips. Plug directly into a grounded wall outlet.
- Inspect control board: Remove the cover to access the main control board. Look for obvious damage such as burnt ICs or cracked components.
- Firmware reset (if available): Some models may have a hidden reset sequence (e.g., holding specific buttons). Refer to the user manual; if available, perform the reset.
- If E9 remains: The memory section of the control board is likely defective. Replace the main control board with the correct Emeril Lagasse part number for your model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements