E9
Gorenje
Internal EEPROM / Configuration Error
Display shows E9 and unit will not start; sometimes occurs after a power surge or lightning storm.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware or EEPROM data on main PCB, Power surge damage, Failed memory IC, Incomplete factory reset
How to Fix / Troubleshooting
Safety first: Disconnect from mains before any disassembly.
- Power cycle: Unplug the air fryer for at least 15 minutes to allow capacitors to discharge. Plug back in and check if the error clears.
- Factory reset (if supported): Consult the Gorenje user manual for a key combination to reset the control (often holding specific buttons while plugging in). Perform the reset and test again.
- Surge protection: If the error appeared after a known surge, inspect the main PCB for burnt components, especially near the power supply section.
- Board replacement: EEPROM or firmware faults on these compact boards are typically not field-repairable. Replace the main control board with the correct Gorenje spare part.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements