E10
Salter
EEPROM / Internal Memory Error
E10 is displayed and the air fryer will not start; sometimes appears after a power surge.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware in control PCB, Failed EEPROM chip, Power surge damage to logic circuit, Poor solder joints on memory IC
How to Fix / Troubleshooting
Safety first: Disconnect from mains before any disassembly. Firmware and PCB work is advanced; consider professional service.
- Power cycle: Unplug the unit for at least 15 minutes to allow full discharge. Plug back in and check if E10 clears.
- Check for surge damage: If E10 appeared after a lightning storm or tripped breaker, inspect the PCB for burnt components, especially near the low‑voltage regulator and memory IC.
- Reseat connectors: Ensure all low‑voltage connectors between the display board and main PCB are firmly seated.
- Firmware reset (if supported): Some Salter models may support a factory reset via a key combination (e.g., holding specific buttons while plugging in). Refer to the service manual if available.
- PCB replacement: If E10 persists and there is no user‑accessible reset, the main control PCB (containing the EEPROM/MCU) must be replaced as a complete unit.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements