E10
Severin EEPROM or Configuration Data Error

E10 displayed; unit beeps and refuses to start, often after a power surge or outage.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted firmware settings in EEPROM, Failed memory IC on main PCB, Incomplete power‑on sequence due to unstable mains, Control board manufacturing defect

How to Fix / Troubleshooting

Safety first: Unplug the air fryer before attempting any reset procedures that involve opening the housing.

  • Extended power reset: Unplug the unit for at least 30 minutes to allow full discharge of internal capacitors. Plug back in and check if the error clears.
  • Factory reset (if available): Consult the Severin manual for a factory reset key combination (often holding specific buttons while plugging in). Perform the reset to reload default parameters.
  • Surge protection: If the error followed a power surge, connect the air fryer through a quality surge protector and test again. However, damage may already have occurred.
  • Board replacement: If E10 persists and no reset procedure is documented, the EEPROM or microcontroller on the main PCB is likely defective. Replace the main control PCB as a complete unit.

Warning: Do not attempt to reprogram firmware without official Severin tools and files; incorrect firmware can render the unit unsafe.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Main Control PCB
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements