Safety: Unplug the air fryer before opening any covers.

Steps:

1. Power cycle: Unplug for at least 10 minutes to allow capacitors to discharge and the microcontroller to fully reset. Plug back in and test.
2. Avoid power disturbances: Do not share the outlet with high‑load appliances (microwave, toaster oven) that may cause voltage dips.
3. Inspect control connections: Remove the top or front panel (depending on model) to access the display/control PCB. Check any ribbon cables or multi-pin connectors between the user interface board and the main power board. Reseat them carefully.
4. Check for heat damage: Look for discoloration or warped plastic around the control board. Ensure internal wiring is not resting directly against hot metal surfaces.
5. Re-test: After reseating connectors, reassemble and run a short cycle. If E8 recurs frequently, the control PCB may have an internal fault.

Note: Firmware in most Sunbeam air fryers is not user-upgradable. Persistent E8 usually requires control board replacement.

E8 error code appears intermittently; unit may shut off mid-cycle without completing the timer.

Possible Causes