Unit drips solution from nozzle when not pressing trigger

Safety first: Unplug the unit and empty the solution tank before working on the valve.

• 1. Check fill level
  • Ensure the clean water/solution tank is not filled above the maximum mark.
• 2. Clean solution valve
  • Remove the tank and locate the outlet valve and corresponding inlet on the machine.
  • Rinse both with warm water to remove detergent residue.
  • Inspect the rubber seal for damage; replace if worn.
• 3. Inspect trigger and internal valve
  • Access the internal solution valve actuated by the trigger.
  • Check for debris preventing full closure and clean as needed.
  • If the valve spring is weak or seal damaged, replace the valve assembly.