Display shows E8; pump runs but no solution reaches the nozzle, and the machine quickly stops spraying.

Safety first: Unplug the unit and relieve any pressure in the solution line by squeezing the trigger with the machine off.

• Clean the spray nozzle: Remove the floor nozzle or spray tip. Soak it in warm water with mild detergent and use a soft brush or toothpick to clear mineral deposits.
• Inspect solution hoses: Check visible hoses from the tank to the pump and from the pump to the nozzle for kinks, pinches, or damage. Straighten or replace as needed.
• Flush the system: Fill the clean water tank with warm water only. Reinstall and run the pump briefly to flush any air or debris, collecting water into a bucket.
• Check flow sensor (if equipped): Some Gorenje models have an in-line flow sensor. Ensure its connectors are secure and that the sensor body is not clogged. Remove and rinse if accessible.
• Replace faulty components: If the flow sensor is defective or the hose is internally collapsed, replace the affected part and re-test.