No water or solution sprays from the floor wand or hand tool

Safety first: Disconnect power and relieve pressure by squeezing the trigger with the machine off before disconnecting hoses.

• Verify solution level: Fill the clean solution tank with the correct water/chemical mix.
• Clean spray jets: Remove the spray nozzles from the floor wand or hand tool. Soak them in warm water or a descaling solution to remove mineral deposits, then gently clean with a soft brush (never use metal pins).
• Check solution filter: Locate and clean the inline solution filter or strainer at the tank outlet or pump inlet.
• Inspect hoses: Follow the solution hose from the tank to the wand. Straighten any kinks and replace hoses that are collapsed or cracked.
• Test pump operation: After reassembly, run the machine and trigger the solution. If the pump is silent, further diagnosis of the solution pump and wiring is required.