No water or solution spraying from the nozzles when the trigger is pressed.

Safety first: Unplug the unit before removing tanks or nozzles.

• Check tank: Fill the clean water/solution tank and ensure the cap and valve are tight. Refit until it clicks into place.
• Prime the pump: Plug in, then hold the trigger for 30–60 seconds while the unit is upright to purge air (if the manual permits).
• Clean nozzles: Remove the front nozzle assembly and soak in warm water. Gently clear each jet with a soft brush.
• If still no spray: The solution pump may have failed and will need replacement.