Vax
Brush Drive Failure
Brush bar not spinning, but suction and spray work normally
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Broken or stretched drive belt, Hair and debris jamming brush bar, Worn brush bar bearings, Failed brush motor (if motorised)
How to Fix / Troubleshooting
Safety first: Unplug the carpet cleaner before working underneath.
- Remove bottom plate: Lay the machine down and remove the screws holding the bottom plate. Lift off to expose the brush bar and belt.
- Inspect belt: Check if the belt is broken, melted, or loose. Replace with the correct Vax belt if damaged.
- Clean brush bar: Remove the brush bar and cut away hair and fibres. Ensure the bar spins freely in its end caps; replace if stiff or worn.
- Check brush motor (if fitted): If there is a separate brush motor, ensure its drive gear is intact and that the motor runs when powered (for trained persons). Replace the motor if faulty.
- Reassemble: Refit the belt, brush bar, and bottom plate securely before use.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Brush Bar Drive Belt
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements