Display shows E08 and the coffee strength or grind settings cannot be adjusted; sometimes the grinder runs continuously.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Misaligned grind selector knob, Broken grind position sensor, Internal wiring issue to grinder sensor, Control board logic fault

Safety: Unplug the unit before adjusting mechanical selectors.

This error is related to the grind setting detection.

Reset selector: Turn the Braun grind selector knob fully from the finest to the coarsest setting several times, then leave it at a mid‑range setting.
Check for obstructions: Ensure no coffee grounds or debris are packed around the selector mechanism.
Power cycle: Plug the unit back in and see if the error clears.

If E08 persists, the internal grind position sensor or control board may be defective and will require professional service.

Medium 3/5

Grind Selector Sensor

Check Price on Amazon

We may earn a commission from links on this page.