Display shows “E2” and heating stops mid-cycle.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Blocked steam/pressure vent in brewer, Excessive scale causing overheating, Failing heating element drawing too much current

Safety first: Unplug and allow to cool fully.

Inspect vents: For Fellow electric brewers with steam vents, ensure vents are not blocked by coffee grounds, paper, or scale.
Descale: Run a full descale cycle using a descaling solution compatible with stainless steel. Rinse thoroughly afterward.
Check water level: Ensure you are not running the unit with too little water, which can cause localized overheating.
If E2 recurs: The heating element or internal thermostat may be failing and should be tested and replaced by a technician.

Hard 4/5

Heating Element / Internal Thermostat

Check Price on Amazon

We may earn a commission from links on this page.