E11
Grundig
Flow Meter Signal Error
E11 appears and the machine stops mid-cycle; water may remain in the internal circuit.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Flow meter blocked by scale, Flow meter wiring loose, Flow meter internal sensor failure, Air in hydraulic circuit
How to Fix / Troubleshooting
Safety first: Unplug the machine before moving or tilting it.
- Bleed air from system: Fill the water tank completely, reinstall, and run several hot water or rinse cycles to remove air bubbles from the flow meter.
- Descale thoroughly: Perform a full descaling cycle to dissolve mineral deposits that may be blocking the flow meter turbine.
- Check water quality: Use filtered or low-mineral water to reduce future scale buildup.
- Service if unresolved: If E11 recurs after descaling and bleeding, the flow meter or its wiring harness may need replacement by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements