Display shows ADD WATR or ADD WATER and brewing will not start or stops mid-cycle.

Safety first: Turn the unit off and unplug before removing the reservoir.

Check water level and seating:

• Remove the water reservoir and fill it at least to the MIN or SMALL CUP line.
• Inspect the bottom outlet valve for debris or coffee grounds; rinse thoroughly.
• Reinstall the reservoir firmly, ensuring it clicks or sits flush on the base.

Clear airlocks and blockages:

• With the reservoir removed, inspect the water inlet on the coffee maker body for scale or debris.
• Use a damp cotton swab to gently clean the inlet area.
• Reinstall the reservoir and gently tap it down to ensure good contact.

Test brew:

• Plug the unit back in, power on, and select a small brew size.
• If ADD WATR still appears despite a full reservoir, try a full descale cycle to clear internal sensors.

If the message persists after cleaning and descaling, the water level sensor or reservoir assembly may be defective and should be replaced.