Display shows ADD WATER or a water droplet icon and the brew cycle will not start.

Safety first: Unplug the coffee maker before removing the reservoir if the unit has been heating.

• 1. Fill and reseat reservoir
  • Remove the reservoir and fill it above the MIN line with fresh water.
  • Reinstall it firmly, ensuring it clicks or seats fully into place.
• 2. Check for trapped air
  • After filling, gently tap the sides of the reservoir to release any trapped air bubbles around the float.
• 3. Clean the float and sensor area
  • Look for a floating piece inside the reservoir; ensure it moves freely.
  • Clean with mild dish soap and water, then rinse thoroughly.
• 4. Sensor inspection (advanced)
  • If the message persists with a full reservoir, unplug the unit and remove the bottom cover.
  • Locate the water level sensor or reed switch under the reservoir area and check for loose wiring or damage.
• 5. Replace faulty sensor
  • If the float is waterlogged or the reed switch is defective, replace the water reservoir sensor assembly with a compatible Sunbeam part.