Vacuum pulses on and off repeatedly while running, especially on carpet

Safety first: Turn OFF and remove the battery before servicing filters.

• Step 1 – Empty and clean bin: Empty the dirt cup and use a soft brush to clean the cyclone shroud holes.
• Step 2 – Deep clean filters: Remove all filters. Tap out dust and, if permitted, rinse foam filters with water. Allow 24 hours to dry.
• Step 3 – Check seals: Inspect the bin and filter seals for deformation or gaps that could cause pressure fluctuations.
• Step 4 – Test without nozzle: Run the vacuum with just the main body (no wand or tools). If pulsing stops, the restriction is in the wand or nozzle; inspect and clear them.