Dreame Mode Selector / Button Matrix Error

F4 code, vacuum cannot switch modes or mode LEDs flash erratically.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck mode button, Contamination under keypad, Damaged button flex cable, Faulty handle PCB

How to Fix / Troubleshooting

Safety: Remove the battery.

Inspect buttons: Press each mode button repeatedly to free any sticking. Ensure full travel and return.
Clean around buttons: Use a dry brush or compressed air to remove dust from button gaps. Do not spray liquids.
Reset: Reinstall the battery and test again.

If F4 persists, the button matrix or handle PCB may need replacement. This requires disassembling the handle and should be done by a professional if you are not experienced.

Repair Difficulty

Hard 4/5

Required Part

Handle Control PCB

Check Price on Amazon

We may earn a commission from links on this page.