ETA Nozzle LED Circuit Failure

Cordless vacuum’s LED work lights on the floor nozzle do not turn on, but the brush and suction still work.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Burned-out LED strip, Broken wire in nozzle, Faulty LED driver on nozzle PCB, Loose LED connector

How to Fix / Troubleshooting

Safety first: Remove the battery and detach the floor nozzle.

  • Check LED connector: If accessible, open the nozzle housing and verify that the LED strip connector is firmly attached to the PCB.
  • Inspect for damage: Look for broken wires or visible damage to the LED strip.
  • Test nozzle function: Reassemble and test. If only the LEDs are non-functional and cleaning performance is unaffected, you may continue using the vacuum, but visibility will be reduced.

When to call a technician: Replacing the LED strip or nozzle PCB is a minor repair but requires opening the nozzle; have it done by an ETA service center if you are not comfortable with disassembly.

Advertisements

Repair Difficulty

Medium 3/5

Required Part

LED Light Strip for Motorized Nozzle
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements