Gtech
Position or Safety Switch Activation
Vacuum runs but stops when tilted or when the floor head is raised off the floor.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty tilt or position sensor, Loose connection in neck joint, Damaged wiring to floor head, Internal safety switch misalignment
How to Fix / Troubleshooting
Safety first: Remove the battery before inspecting joints and wiring.
Steps to try:
- Observe pattern: Note whether the vacuum always stops at a certain angle or when the head is lifted.
- Inspect neck joint: Check for visible damage or excessive play where the floor head connects to the main body or tube.
- Wiggle test: With the battery fitted, gently move the neck while running the vacuum. If it cuts out, internal wiring or a position sensor is likely faulty.
- Replace affected assembly: Depending on the model, this may require replacing the floor head, tube, or main body where the sensor is located.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Motorised Floor Head Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements