F2
Levoit
Power Mode Control / Button Fault
Vacuum shows F2 and runs only at low power, ignoring higher power settings
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective power mode switch on handle, Contaminated mode button contacts, Faulty main PCB interpreting mode signals, Damaged ribbon cable between handle and main board
How to Fix / Troubleshooting
Safety first: Remove the battery before inspecting buttons or handle connections.
- Check for stuck buttons: Press the power and mode buttons repeatedly to feel for sticking or lack of click. If sticky, lightly clean around the button with a dry cloth.
- Inspect for liquid damage: Look for signs of spills or moisture around the handle. If liquid entered, do not continue use; internal corrosion may be present.
- Soft reset: Remove the battery for 5 minutes, then reinstall and test mode changes again.
- If F2 persists: The handle switch assembly or main PCB likely needs replacement. This requires disassembly and should be done by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Handle Switch Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements