Makita LED Indicator Circuit Failure

LED indicators on the vacuum do not light, but the motor runs.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed LED module, Damaged LED driver on PCB, Loose LED connector, Previous impact or moisture damage

Safety first: Remove the battery before inspection.

Confirm operation: Verify that suction and modes still function normally; only the LEDs are affected.
Check for cracks: Inspect the LED lens area for cracks or signs of impact.
Use battery gauge: Rely on the battery’s own fuel gauge (if equipped) to monitor charge until the LED issue is resolved.
Service recommendation: LED replacement typically requires access to the main PCB or LED board. Have a Makita service center replace the LED module or control PCB as needed.

Hard 4/5

LED Indicator Board

Check Price on Amazon

We may earn a commission from links on this page.