Toshiba
Excessive Suction / Incorrect Floor Setting
Vacuum is difficult to push on carpets; nozzle seems to stick to the floor
Advertisements
Possible Causes
Using high power mode on delicate carpet, Worn or missing nozzle glide wheels, Nozzle height too low, Blocked relief vents on nozzle
How to Fix / Troubleshooting
Safety first: Turn OFF the vacuum before inspecting the nozzle.
- Step 1 – Change power mode: Switch to a lower suction mode or carpet setting if available.
- Step 2 – Inspect wheels and sliders: Check that all nozzle wheels roll freely and that felt pads or sliders are intact.
- Step 3 – Check relief vents: Ensure any small vents or slots on the nozzle base are not blocked by tape or debris.
If the nozzle base is warped or wheels are damaged, replace the motorized nozzle assembly.
Advertisements
Repair Difficulty
Very Easy
1/5
Required Part
Motorized Floor Nozzle Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements