Toshiba Latch / Mode Logic Fault

Vacuum runs only when the trigger is held and will not stay on in continuous mode

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Continuous mode button failure, Firmware glitch, Broken latch mechanism in trigger, Control PCB fault

Safety first: Remove the battery before inspecting controls.

Step 1 – Check user settings: Some Toshiba models require a specific button combination to enable continuous mode; verify in the manual.
Step 2 – Power cycle: Remove the battery for 5 minutes, reinstall, and test continuous mode again.

If continuous mode still does not engage, the control PCB or latch mechanism may need professional repair.

Medium 3/5

Handle Control Panel PCB

Check Price on Amazon

We may earn a commission from links on this page.