AEG
Partial Drain / Residual Water
Dishwasher leaves water at the bottom after the cycle, but no error code is shown.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked filter system, Partially clogged drain hose, Incorrect drain hose installation height, Weak drain pump on AEG dishwasher
How to Fix / Troubleshooting
Safety first: Unplug the appliance before working on the drain system.
- Clean filters and sump: Remove and clean all filters. Check the sump for debris.
- Check drain hose routing: Ensure the hose rises to the correct height (usually 40–85 cm) and is not looped on the floor, which can cause siphoning issues.
- Inspect sink connection: Remove the hose from the sink trap spigot and check for blockages. Clean if necessary.
- Test drain function: Run a drain-only or cancel cycle and observe the water level. If water remains and the pump sounds weak, consider replacing the drain pump.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements