Asko General Fault / Overfill or Leak Protection Triggered

Dishwasher stops mid-cycle and all lights flash or beeps repeatedly without a specific code.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Water in base pan, Door opened during critical phase, Temporary control glitch, Power fluctuation

Safety: Turn off power and water before inspecting the base.

Check for water in base: Remove the kick panel and inspect the base pan. Remove any water and look for leaks.
Reset the unit: Turn off power at the breaker for 5–10 minutes, then restore and try a short cycle.
Observe operation: Run the dishwasher while monitoring for leaks or unusual behavior.
If problem recurs: Identify whether it coincides with filling, washing, or draining to narrow down the faulty system (inlet, pump, or leak protection) and repair accordingly.

Medium 3/5

Anti-Flood Float Switch

Check Price on Amazon

We may earn a commission from links on this page.