E10
Balay
Heat Pump / Drying System Fault (Model-dependent)
Dishwasher shows E10 and may stop during drying; sometimes accompanied by poor drying results.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty heat pump sensor, Overheating detected in drying circuit, Defective NTC sensor on heater, Control board temperature monitoring fault
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing internal components.
- Allow cooling: If the dishwasher is very hot inside, leave the door open and allow it to cool completely. Then reset power and try another cycle.
- Check ventilation: Ensure the kitchen cabinet has adequate ventilation around the dishwasher. Overheating can trigger E10.
- Inspect wiring to sensors: Access the heater/heat pump area and check the NTC sensor wiring for damage or loose connectors.
- Run a test program: After reseating connectors, run a short program and monitor for recurrence of E10.
- Professional service: If E10 persists, the NTC sensor, heat pump, or control module may need replacement. This should be done by a qualified technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
NTC Temperature Sensor / Heat Pump Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements