Dishwasher shows combined code F6 E1 (or 6-1 via blinking LEDs) and does not fill properly.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Closed water tap, Kinked inlet hose, Blocked inlet filter, Defective flow meter or Aquastop

Safety first: Disconnect power and close the water tap.

Open tap fully: Ensure the water tap is fully open and supplying water.
Inspect hose and filter: Straighten any kinks in the inlet hose and clean the mesh filter at the tap and Aquastop end.
Check flow meter: Access the water intake assembly and verify that the flow meter wheel turns freely when water flows. Replace the assembly if stuck or not sending pulses.
Re-test: Restore power and run a short cycle to confirm normal filling.

Medium 3/5

Aquastop Inlet Hose Assembly

Check Price on Amazon

We may earn a commission from links on this page.