Dishwasher displays E14 and may not start or may stop early in the cycle.

Safety first: Unplug the dishwasher before accessing the control module.

• Power reset: Turn off the mains supply for at least 10 minutes to allow the control to fully discharge, then restore power and try a short cycle.
• Check supply: Ensure the wall socket and plug are in good condition and that there are no signs of overheating.
• Inspect control board: Remove the inner door panel to access the Baumatic control module. Check for burnt components, corrosion, or loose connectors.
• Secure connections: Reseat all wiring harness plugs to the control board and user interface.
• Replace control: If E14 persists and there are signs of board damage or no other faults found, the control board will likely need replacement. This should generally be done by a qualified technician.