E14
BECKEN
Flow Meter Signal Error
Dishwasher shows E14 and may fill erratically or stop mid-cycle; water usage seems abnormal.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective flow meter, Blocked water matrix, Loose flow meter connector, Control board input fault
How to Fix / Troubleshooting
Safety first: Turn off power and water supply before removing side panels.
- Access flow meter: On Becken models with a side water matrix, the flow meter is usually integrated into the plastic water distributor on the left side.
- Clean water matrix: Remove the matrix if possible and flush with warm water to remove scale and debris that may impede the flow meter wheel.
- Inspect sensor and wiring: Check the small flow meter sensor and its connector for damage or corrosion. Reseat the connector.
- Test operation: Reassemble, restore water and power, and run a short cycle while listening for normal filling. If E14 returns, the flow meter may need replacement.
Replacing the flow meter or water matrix requires careful handling of seals; if unsure, use a professional.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Flow Meter / Water Matrix Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements