E16
BECKEN Inlet Valve Stuck Open / Overfill Protection

Dishwasher shows E16 and may continuously fill or overflow when powered.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Mechanically stuck water inlet valve, Debris in valve seat, Shorted inlet valve coil, Control board stuck relay

How to Fix / Troubleshooting

Safety first: Immediately close the water tap and switch off power at the breaker to stop filling.

  • Observe behavior: If water continues to enter the Becken dishwasher even when it is switched off, the inlet valve is mechanically stuck open.
  • Access inlet valve: Remove the lower front or side panel to locate the inlet valve where the aqua-stop hose connects.
  • Inspect for debris: Disconnect the hose and check for debris lodged in the valve seat. In most cases, the valve must be replaced rather than cleaned.
  • Check wiring and board: If water only flows when the appliance is powered, the control board may be energizing the valve continuously due to a stuck relay.

Replace the inlet valve assembly if it is stuck or leaking. If the valve tests good but is held open electrically, the control board will need repair or replacement.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Water Inlet Valve with Aqua-Stop
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements