Dishwasher displays F1; unit may not start or may stop shortly after starting.

Safety first: Turn off power at the breaker and shut off the dishwasher water supply valve under the sink.

• Check water supply: Ensure the shutoff valve is fully open. Verify that other fixtures on the same line have good pressure.
• Inspect inlet hose: Look under the sink and behind the dishwasher for kinks or sharp bends in the stainless or braided inlet hose. Straighten as needed.
• Clean inlet screen: Turn off water, disconnect the inlet hose from the dishwasher valve, and inspect the small screen inside the valve fitting. Clean any sediment or debris with a soft brush.
• Test fill: Reconnect the hose, restore water and power, and start a cycle. Listen for water entering the tub. If F1 returns and no water enters, the inlet valve may be defective.
• Replace inlet valve if needed: Pull the dishwasher out, access the valve (usually on the left or right underside), disconnect wiring and hoses, and install a new Café-compatible water inlet valve.