Dishwasher stops mid-cycle, may show water in base or not drain correctly, E07 displayed.

Safety first: Unplug the dishwasher before removing side or top panels.

• 1. Check for obvious blockages: Inspect the interior top and sides for any plastic items or labels blocking the vent openings.
• 2. Access the fan unit: On many Constructa models, the drying fan is located behind the left or right side panel near the top. Remove the panel and visually inspect the fan housing.
• 3. Clean the fan and ducts: Remove dust, grease, and lint from the fan blades and air channels using a soft brush and vacuum. Ensure the air flap (if present) moves freely.
• 4. Wiring check: Confirm the fan's electrical connector is firmly attached and wires are not damaged.
• 5. Test operation: Reassemble, restore power, and run a drying-intensive program. Listen for the fan running during the drying phase.

When to call a technician: If the fan does not run or E07 returns, the fan motor or control board output may be defective and should be tested by a professional.