E14
Constructa
Flow Meter / Water Intake Signal Fault
Dishwasher stops filling or behaves erratically during fill, E14 displayed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective flow meter sensor,Blocked or air-locked water matrix,Loose flow meter wiring,Control board not receiving pulses
How to Fix / Troubleshooting
Safety first: Disconnect power and close water tap.
- 1. Clean inlet filter and ensure good flow: As with E02/E03, verify the inlet filter is clean and water pressure is adequate.
- 2. Inspect water matrix and flow meter: Remove the left side panel. Locate the flow meter on the water matrix. Check for visible blockages or air pockets in the channels.
- 3. Reseat connector: Disconnect and reconnect the flow meter's electrical plug to ensure a solid connection.
- 4. Descale if needed: If the matrix is heavily scaled, remove and descale it, then reinstall.
When to call a technician: Persistent E14 usually indicates a failed flow meter or control board, requiring professional diagnosis.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements