E16
Danby
Inlet Valve Stuck Open / Overfill Condition
Dishwasher displays E16; unit may overfill or drain unexpectedly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Debris in inlet valve preventing closure, Defective inlet valve diaphragm, Control board stuck energizing valve, Wiring short to valve
How to Fix / Troubleshooting
Safety first: Turn off power and close the water supply valve immediately if overfilling is observed.
- Observe water behavior: With power off, open the door and check if water continues to enter. If so, the inlet valve is mechanically stuck open.
- Inspect inlet valve: Remove the lower panel and check the valve for debris or scale. Replacement is usually more reliable than attempting to rebuild.
- Replace inlet valve: Install a new water inlet valve, ensuring all connections are tight and leak-free.
- If water only flows when powered: The control board may be energizing the valve incorrectly. Inspect wiring for shorts and consider control board diagnosis.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Water Inlet Valve
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements