Fagor
Extended Cycle Time / Program Stalling
Dishwasher runs for an unusually long time or seems stuck on one part of the cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Heater not reaching temperature, Faulty NTC sensor causing repeated heating attempts, Low inlet water temperature, Excessive foaming or turbidity sensor misreading
How to Fix / Troubleshooting
Safety first: Disconnect power before testing heater or sensors.
- Check water temperature: Run the hot tap before starting the dishwasher to ensure hot water enters from the beginning.
- Observe heating: After 20 minutes of operation, the door should feel warm. If not, investigate heater and NTC as in heating fault entries.
- Detergent: Use the correct amount of dishwasher detergent to avoid excessive foam, which can confuse sensors.
- Clean turbidity sensor: Clean the sump and turbidity sensor window as described in F6.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Fagor heater / NTC sensor / turbidity sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements