Fagor Generic Fault / Safety Shutdown

Dishwasher stops mid-cycle and all lights flash, but no specific error code is shown.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Momentary power interruption, Overheating of motor or heater, Control board glitch, Door opened during critical phase and not re-latched properly

Safety first: Turn off power at the breaker before inspecting internal components.

Power reset: Switch off the breaker or unplug the Fagor dishwasher for 5–10 minutes, then restore power and try a short cycle.
Ventilation: Ensure the dishwasher has adequate ventilation around the cabinet and is not overheating.
Door latch: Confirm the door closes firmly and the latch engages fully.
Monitor: If the issue repeats, check for overheating signs on the motor and heater, and consider professional diagnosis of the control board.

Medium 3/5

Fagor main control board or door lock

Check Price on Amazon

We may earn a commission from links on this page.