Dishwasher displays E5; unit may stop during filling or show irregular water levels.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Blocked pressure hose, Faulty pressure switch, Grease buildup in air trap, Wiring fault to level sensor

Safety first: Disconnect power and water before removing side panels.

Clean air trap: Access the side of the tub and locate the pressure chamber. Flush with hot water to remove grease.
Clear hose: Remove the small pressure hose and blow through it to ensure it is clear.
Check switch: Test the Fagor pressure switch with a multimeter while gently blowing into the hose port; contacts should change state.
Replace sensor: If the switch does not respond, replace the water level pressure switch.

Hard 4/5

Fagor water level pressure switch

Check Price on Amazon

We may earn a commission from links on this page.