F10
Fagor
Flow Meter / Water Intake Measurement Fault
Dishwasher shows F10; may not start or may stop shortly after starting, sometimes with no water entering.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty flow meter in inlet assembly, Blocked flow meter turbine due to debris, Wiring issue between flow meter and control board, Incorrect installation of inlet assembly
How to Fix / Troubleshooting
Safety first: Unplug the dishwasher and close the water tap before disconnecting the inlet hose.
- Check inlet filters: Remove and clean the mesh filter at the tap end of the Fagor inlet hose to prevent debris from reaching the flow meter.
- Access flow meter: On many Fagor models, the flow meter is integrated into the water inlet assembly or side water matrix. Remove the side panel to locate it.
- Inspect for debris: Disconnect the small hoses and gently flush the flow meter with clean water to free any stuck particles.
- Check wiring: Ensure the flow meter connector is firmly attached to the control board harness and that no wires are broken.
- Replace if faulty: If the turbine does not spin freely or the sensor is damaged, replace the Fagor flow meter/inlet assembly.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Fagor flow meter / water inlet assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements