E17
Finlux
Drain / Fill Sequence Error
Dishwasher shows E17 and may stop during drain or fill transitions.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked drain hose causing slow emptying, Partially blocked sump filter, Faulty pressure sensor not detecting empty state, Control board timing fault
How to Fix / Troubleshooting
Safety first: Disconnect power before clearing hoses or filters.
- 1. Clean filters: Remove and thoroughly clean the sump filters to ensure unrestricted water flow.
- 2. Check drain hose routing: Ensure the hose rises in a high loop under the worktop and is not kinked or crushed.
- 3. Clear sink spigot: Disconnect the hose from the sink drain spigot and clear any blockage.
- 4. Pressure sensor check: If accessible, clean the pressure hose and chamber as described for E5/E11.
- 5. Test cycle: Run a rinse program and observe filling and draining. If E17 persists, the pressure sensor or control board may require replacement.
- 6. Professional help: For persistent sequence errors, contact a technician for sensor and PCB diagnostics.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements