E19
Finlux
Dispenser Solenoid / Control Fault
Dishwasher shows E19 and may have issues with detergent or rinse aid dispensing.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed detergent dispenser solenoid, Jammed dispenser lid, Broken dispenser wiring, Control board output fault
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the inner door panel.
- 1. Inspect dispenser: Open the door and check that the detergent lid opens and closes freely by hand. Clean away any hardened detergent.
- 2. Access wiring: Remove the inner door panel to expose the back of the dispenser. Check the solenoid connector and wiring for damage.
- 3. Visual check: Look for cracks or burn marks on the dispenser body.
- 4. Replacement: If the solenoid is open-circuit or the mechanism is broken, replace the complete detergent and rinse aid dispenser assembly.
- 5. Test: Reassemble the door and run a cycle to confirm the dispenser opens at the correct time.
- 6. Technician note: If a new dispenser does not resolve E19, the control board output may be faulty and requires professional diagnosis.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Detergent Dispenser Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements