Dishwasher not draining but no error code displayed; water remains at the bottom after cycle completes.

Safety: Switch off and unplug the dishwasher before working inside the tub or on hoses.

Clean internal filters:

• Remove lower basket and take out all filter components in the base.
• Rinse under hot water and scrub away grease and food particles.

Check sump and pump:

• Use a torch to look into the sump opening; remove any visible debris.
• If accessible, remove the small pump cover and check the impeller area for obstructions.

Drain hose and installation:

• Ensure the drain hose rises in a loop to the underside of the worktop before going to the sink trap; this prevents backflow.
• Disconnect the hose at the sink trap and flush it through with hot water.

Run a rinse cycle to confirm that water now drains fully.