Dishwasher does not drain, water remains in the bottom of the tub, and F05 or 5 flashes are indicated.

Safety: Disconnect power and be prepared for water spillage when removing hoses.

Internal filter and sump:

• Open the door and remove the lower basket.
• Lift out the coarse and fine filters in the base. Rinse thoroughly under hot water.
• Use a sponge to remove standing water from the sump so you can see the pump cover.

Check the drain pump:

• Remove the small cover over the drain pump (if accessible from inside). Check for glass, food, or labels obstructing the impeller.
• From underneath (remove lower panel), locate the drain pump on the side of the sump. Disconnect the hose and electrical connector.
• Inspect the impeller for damage and ensure it spins freely.

Drain hose and sink connection:

• Follow the drain hose to where it connects to the sink trap or waste disposal.
• Remove the hose and check for blockages or a blanking plug left in a new trap spigot.
• Flush the hose with hot water to clear grease build‑up.

Reassemble and test:

• Refit the pump and hoses securely, ensuring all clamps are tight.
• Restore power and run a drain or cancel cycle to confirm proper emptying.

If the pump hums but does not turn, or is electrically open, replace the drain pump.