Kenmore Intermittent Control or Overheat Issue

Dishwasher stops mid-cycle and will not continue until reset.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Overheating control board, Loose wiring connection, Failing door switch, Motor overheating and tripping internal protector

Safety first: Disconnect power before inspecting internal components.

Note when it stops: Determine if it stops during wash, drain, or heat to narrow down the component.
Inspect wiring: Check harness connections at the control board, door switch, and motors for looseness or heat damage.
Test door switch: Replace if intermittent or loose.
Check motor temperature: If the circulation pump is extremely hot when it stops, it may be failing and should be replaced.

Hard 4/5

Circulation Pump Motor

Check Price on Amazon

We may earn a commission from links on this page.