Kenmore Heating Element / Temperature Fault

Dishwasher displays E2 and may not heat or may end cycle with dishes still wet.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open heating element, Failed thermostat, Faulty temperature sensor, Control board heater relay failure

Safety first: Disconnect power and allow the unit to cool.

Inspect and test heater: Check for visible damage and test continuity. Replace if open.
Check thermostat: Locate and test the high-limit thermostat for continuity. Replace if open at room temperature.
Test temperature sensor: Measure resistance and compare to spec; replace if out of range.
Control relay: If all components test good, the control board’s heater relay may be defective and require replacement.

Hard 4/5

Heating Element

Check Price on Amazon

We may earn a commission from links on this page.