F6E6
Maytag
Inlet Water Temperature Out of Range
Dishwasher stops and displays a water temperature or inlet-related error; may be labeled F6E6.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incoming water too cold, Faulty thermistor reading, Control misinterpreting temperature
How to Fix / Troubleshooting
Safety First: Turn off power before accessing internal components.
Steps:
- Verify hot water: Run hot water at the sink until it is fully hot before starting the dishwasher. Ensure water heater is set to at least 120°F (49°C).
- Check thermistor: Access and test the thermistor as described for F3E1. Incorrect readings can cause temperature-related inlet errors.
- Control reset: Perform a power reset by turning off the breaker for 5 minutes, then retry.
- Replace faulty sensor or control: If water temperature is correct but the error persists, replace the thermistor. If still unresolved, the main control may need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Thermistor / Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements